Trudo Albert price $275 plus shipping


Contact us to set up a demonstration or to order.


sales@TrudoAlbert.com    740-391-0111


 The AC HotStick consists of a high sensitivity AC amplifier for the frequency range below 100 Hz. The special logarithmic amplifier is capable of receiving AC signals over a very wide amplitude range. Such signals, emanating from an unshielded, voltage-carrying surface, can be made audible and visible as a signal. The warning signal (beeps and LED flashes) become more rapid as the AC HotStick approaches the source, making source location quick. In the presence of high tension wires the sensitivity can be reduced by selecting the Low sensitivity or the Front focused mode. The sensitive section of the AC HotStick is located in the red striped area. When used in the High or the Low sensitivity mode the unit will respond to signals from all sides (omni-directional sensitivity). When the Front Focused mode is selected the unit responds only to signals received from the front of the AC HotStick. This reduces the sensitivity and concentrates detection into a small frontal area, permitting pinpointing of the source and distinguishing between adjacent wires. The detector will not respond to DC voltages from car batteries or from the third rail in light rail transit vehicles operating on DC. The unit features a complete self-test circuit: Immediately after turning the unit on, a built-in, low frequency oscillator will operate for about 3 seconds simulating power line signals. Rapid beeping for about 3 seconds indicates proper operation of the unit. A low voltage watchdog circuit monitors the battery power. If battery power is too low, the unit will make a constant warning beep, alerting the user to replace the batteries. The unit requires virtually no warm-up and is operational about 10 seconds after being turned on. In normal use with intermittent operation, a set of standard AA alkaline batteries will typically provide one year of service. If left on continuously the batteries will run down in about 300 hours. In order to assure operation and prevent battery leakage, the batteries should be changed annually. After unscrewing the lanyard the batteries are accessible. Batteries should only be changed in a clean, dry atmosphere. The electronic circuitry is mounted on a printed circuit board housed in a sturdy, fully insulated plastic pipe. The set is splash-water proof. It has been designed for operation in potentially explosive atmospheres. Hermetically sealed switches and quality components provide reliable operation and long life even in severe environments.
The AC HotStick is a safety device designed for professional rescuers which provides warning of exposed high voltage AC from a safe distance. The AC HotStick will give early audible (“beeping”) and visual (flashing LED) warning of the presence of dangerous voltages without the need to contact the surface carrying the current. The closer the user comes to the source of the voltage, the more rapidly the unit beeps and flashes. The tool has found many applications, especially with first responders, fire, police, and EMT’s responding to vehicular accidents; with search and rescue operations in urban and rural settings; and with clean up crews working on downed trees after wind and ice storms. However, industrial users, and anybody else who may unknowingly be exposed to the dangers of electrical shock and electrocution, will find the AC HotStick a necessity. It is simple to use and is well constructed. It comes with a built in self test so there is never any doubt about it functioning properly. It has also gained numerous functionality improvements through years of customer feedback. All of these things have made the AC HotStick an invaluable safety tool with a devoted following.
Trudo Albert Fire Equipment L.L.C.             TrudoAlbert.com                    740-391-0111